非预混条件下的旋转爆轰燃烧室双波头演化过程数值模拟

针对旋转爆轰燃烧室双波头演化过程中流场结构变化的问题,对非预混条件下的旋转爆轰燃烧室从起爆到形成稳定的双波头过程进行了数值模拟研究。研究结果表明,从起爆到形成稳定爆轰过程,燃烧室主要经历了起爆、爆轰波对撞和稳定爆轰三个阶段；在爆轰波对撞阶段,首次对撞是两个爆轰波间的对撞,由于对撞点处缺少新鲜混合气,从而在对撞结束后衰减为两个压力波。第二次对撞是两个压力波间的对撞,因为在第二次对撞点附近存在新鲜混合气来支撑爆轰波的持续传播,故对撞结束后产生了一个爆轰波和一个较弱的压力波；第二次对撞发生后,燃烧室内的压力波反射叠加并形成局部高压区,此高压区压缩气体使气体温度升高,高温气体引燃混合气后,最终发展成为第二个爆轰波；稳定阶段,两个爆轰波均能稳定自持传播,爆轰波峰面压力可达1.45MPa,波后温度为2500K,爆轰波速度稳定在1738m/s,产生的推力与比冲分别为79.76N和2312.15s；斜激波的存在使燃烧室出口平面流场产生了较大波动。      

Assessment on critical technologies for conceptual design of blended-wing-body civil aircraft

Civil aviation faces great challenges because of its robust projected future growth and potential adverse environmental effects. The classical Tube-And-Wing(TAW) configuration following the Cayley's design principles has been optimized to the architecture's limit, which can hardly satisfy the further requirements on green aviation. By past decades' investigations the BlendedWing-Body(BWB) concept has emerged as a potential solution, which can simultaneously fulfill metrics of noise, emission and fuel burn. The purpose of the present work is to analyze the developments of critical technologies for BWB conceptual design from a historical perspective of technology progress. It was found that the high aerodynamic efficiency of BWB aircraft can be well scaled by the mean aerodynamic chord and wetted aspect ratio, and should be realized with the trade-offs among stability and control and low-speed performance. The structure concepts of non-cylinder pressurized cabin are of high risks on weight prediction and weight penalty. A static stability criterion is recommended and further clear and adequate criteria are required by the evaluations of flying and handling qualities. The difficulties of propulsion and airframe integration are analyzed. The energy to revenue work ratios of well-developed BWB configurations are compared,which are 31.5% and 40% better than that of TAW, using state-of-art engine technology and future engine technology, respectively. Finally, further study aspects are advocated.     

电磁测力系统研究

介绍了电磁测力系统中静磁场分析与优化、通电线圈位置控制方法及提高线性度的自校准方法。运用Maxwell 3D进行仿真计算，得到了相对优化的磁密及磁均匀性，通过控制通电线圈在磁场中位置及分段线性微分技术，提高了电磁测力准确度。构建了试验装置，对比试验数据表明，该研究措施对于提高电磁测力准确度取得了较好效果。     

Statistical characteristics of low latitude Pc4s: Influence of solar wind and IMF parameters

Pc4 signatures for the year 2013, extracted from geomagnetic north–south and east–west components of induction coil magnetometer (LEMI 30) from low latitude station Desalpar (DSP), operated by Institute of Seismological Research (ISR), India have been investigated vis-à-vis the prevalent interplanetary parameters (IMF) as well as the geomagnetic activity indices. A clear dominance of Pc4-5 (467 events) over Pc3 (17 events) is observed. Local time variation of Pc4 shows a peak in the noon sector in both X and Y components. Our investigations show that the dominant peak frequency is 10 mHz at low latitude region. Correlations with solar wind and IMF parameters illustrate highest occurrence of Pc4 for a solar wind speed of 300–400 km/s and average IMF B field of 3–6 nT. The amplitude of Pc4s at DSP shows an increase with increasing solar wind speed, plasma density, solar wind dynamic pressure and average B field which is also reflected in the trend of frequency variation of these pulsations. We report that IMF clock angle at low latitude does not have influence on Pc4 occurrence. Based on the characteristics of these events, detected in latitudinally distributed stations from low and mid-latitudes from northern and southern hemisphere, we infer that modes were compressional, which could be driven by K-H instability or solar wind dynamic pressure, as compressional modes can propagate to low latitude with little attenuation.     

基于超螺旋二阶滑模的双馈风力发电机控制策略

传统双馈风力发电机(DFIG)控制存在抖振现象,容易造成系统的不稳定。为了减轻控制抖振现象,提高控制的稳定性,在分析了DFIG动态特性的基础上,建立了DFIG的数学模型,设计了超螺旋二阶滑模控制器,并研究了突变风的情况下滑模控制器的控制性能。通过MATLAB/Simulink工具进行了仿真验证。仿真结果证明:滑模控制器具有良好的最优转矩跟踪能力和无功调节能力,与一般的控制方法相比鲁棒性较强,转子控制电压连续,控制产生的抖振可以大幅减轻,系统的稳定性大大提升。     

基于两相流模型的挤压油膜阻尼器空化流场特性数值模拟

基于气液两相流理论中的Mixture模型和Zwart-Gerber-Belamri空化模型,采用动网格技术建立了两端开口中心槽供油型挤压油膜阻尼器三维非定常空化流场求解模型。数值模拟表明:随着阻尼器内环进动,考虑两相流动的油膜低压区在中心槽的两侧产生两道对称的条状负压带,条状带内具有较高的气相体积分数;阻尼器低压区的压力和气相体积分数对进油孔位置十分敏感,阻尼器油膜力和流场气穴比的变化频率与进油孔数密切相关。内环同心进动半径、进动频率对阻尼器空化流场影响的数值计算表明,进动半径和频率的增大均会使得流场内的空化现象加剧,同时气穴比的相位滞后现象愈加显著。      

高空飞行环境中液体运载火箭底部热环境研究

采用数值模拟和飞行测试验证相结合的方法对液体运载火箭高空对流/辐射耦合换热问题开展系统深入研究。基于燃气多组分输运Navier-Stokes方程、热辐射方程、Realizable k-ε两方程湍流模型，建立了高空含自由流的运载火箭燃气喷流流动模型。辐射模型采用离散坐标法(DOM)，空间离散采用二阶迎风TVD格式，对多个典型飞行高度火箭底部热流进行大型并行计算，将数值结果与试验数据进行广泛对比，验证了计算模型的精度和有效性。数值研究表明，火箭底部辐射热流在刚起飞阶段达到最大值，随着飞行高度上升，辐射热流逐渐降低，火箭底部对流热流表现为先升高后降低的趋势，并在20 km高空达到峰值。本文的预测分析方法对液体运载火箭底部热防护设计具有重要的理论意义和工程应用价值。     

喷雾器喷嘴出口喷流流场特性的实验研究

通过定性定量实验手段研究了以水为单介质流体的某农用喷雾器喷嘴出口流场。首先采用单反相机常规拍摄方法,记录了喷雾压力在50～4 000 Pa范围内的喷嘴出口流场,发现了随着喷雾压力增大,喷嘴出口射流的形状经历了形成液泡到液泡破裂的过程,以及射流发展及最终稳定过程。然后通过PIV测速技术对喷雾压力在1 000～4 000 Pa范围内的喷嘴出口流场进行了定量测量实验研究,获得了在纵向截面上,喷嘴出口速度随喷雾压力增大而增大,且在中心线上的速度随着离喷口距离的增加均呈现振荡衰减的变化规律。在同一位置横向截面上,随着喷雾压力的增加,旋流强度越强,流速越大;而在同一喷雾压力下,离喷嘴出口距离越近的横截面处旋流强度越大,流速也越大。本文实验研究结果验证了PIV测速技术可以用于水雾滴的速度场测量。     

基于二阶滑模算法的永磁电机直接转矩控制

针对传统直接转矩控制(DTC)方法低速控制精度差、转矩脉动大、开关频率不稳定等问题,提出了一种基于二阶滑模控制的永磁电机DTC方法。该控制方法基于二阶滑模控制原理,将传统磁链控制器与转矩控制器以滑模控制器替代,对空间电压进行矢量调制,提高了开关频率的稳定性,获得了良好的动态稳定性,改善了电机输出性能。仿真与试验结果表明,该控制方法能够有效减小电流脉动与转矩脉动,同时提高了控制系统的抗干扰能力,实现了电机的快速动态响应,具有较强的鲁棒性能。     

Streamwise vortex generation by the rod

The technology development related to aerodynamics is leading to ever increasing loads of wings, airfoils and turbine and compressor blades. The increase in aerodynamic forces is often leading to flow separation and depreciation of the aerodynamic performance of flying objects or propulsion systems. Flow control methods are required to avoid these negative effects. In the recent two decades the flow control by means of air-jet vortex generators has been also intensively investigated. In this method a streamwise vortex is introduced by an oblique jet. The necessity to supply air by a pipe system may be considered a disadvantage. In order to eliminate this feature, it has been proposed to put out a rod instead of a jet. It has been shown that the application of a rod can introduce the same effect as a jet, as long as the streamwise vortex generation is concerned and appropriate dimensions are used. The present paper focuses on the influence of rod vortex generators on a flow pattern downstream. The results presented here concern experimental and numerical investigations and provide guidelines for the design of a new flow control method dedicated mainly to external flows.